Handy Hints; Sawdust Removal - Black & Decker CD600 User Manual

it and give the blade time to pursue its path. Use the
mark (17) for straight cuts or the mark (18) for mitring
cuts, to keep to the line you have drawn.
MAINTENANCE OF THE WINDOW
From time to time, it may become necessary to remove
cutting debris/dust from the inside of your circular saw
window.
To do this, proceed as follows:
Disconnect the plug from the electricity supply.
When finished, simply slide the lever back towards the
rear of the saw guard in order to restore the window
into its operating position.
Note: If necessary, use only mild soap to clean your
saw as many household cleaners contain chemicals
which could seriously damage the plastic. Also, do not
use petrol, turpentine, laquer or paint thinners or
simular products. Never let any liquid get inside your
circular saw and never immerse any part of it into liquid.
REPLACING THE CARBON BRUSHES
Proceed as follows:
Disconnect the plug from the electricity supply.
Unscrew the brush cover (11). Withdraw the carbon
brush and holder. Remove the carbon brush from the
brush holder. Insert the new carbon brush in the brush
holder. Insert the carbon brush and brush holder in
the housing. Fit the brush covers.
Note: Replace the brushes in pairs and ensure used
brushes and brush holders are fitted in the same
positions as when removed.

SAWDUST REMOVAL

CD600 Circ saw ML p01-41
Slide the window lever
(2) forward to expose
the soiled portion of the
window.
Take a clean, lint free
cloth and proceed to
wipe the exposed part of
the window as required.
For sawdust removal,
you can use a vacuum
cleaner with a
conventional flexible
connection inserted in
the dust collection
outlet.
29

HANDY HINTS

Some splintering is inevitable on the topside line of cut.
It is therefore desirable to cut on the side of the
workpiece where splintering is acceptable. This is
especially important when cutting laminates.
TOOL CARE
• Guide your circular saw but do not force it through
the work. Applying excessive pressure can cause
your circular saw to overheat. If your circular saw
becomes too hot, operate it off-load for 2 minutes.
• Always keep the air cooling vents on the motor
housing clear.
EC DECLARATION OF CONFORMITY
We declare that units:
CD600, KS227, KS840, KS846N, KS850N,
KS855N, KS865N, KS865KN, 374456N
conform to 89/392/EEC, 89/336/EEC, EN55014,
73/23/EEC, EN55104, EN50144, EN61000
A weighted sound pressure 92.7dB (A)
A weighted sound power 102.1dB (A)
Hand/arm weighted vibration <2.5m/s
Brian Cooke - Director of Engineering
Black & Decker Ltd, Spennymoor, County Durham
DL16 6JG United Kingdom
The Black & Decker policy is one of continuous
improvement to our product and as such we reserve
the right to change the product specification without
prior notice.
07/01/2000, 3:43 pm
ENGLISH
2
29