(Original instructions) ENGLISH Intended use 6. Do not force the tool It will do the job better and safer at the rate for which it was Your Black & Decker Chop Saw has been designed for the intended. cutting of variously shaped steel materials. This product is intended for consumer use only.
(Original instructions) ENGLISH 16. Remove adjusting keys and wrenches Never reach in the back of the cutting disc. Always check that adjusting keys and wrenches are removed Always position the tool on a flat, stable surface that is from the tool before operating the tool. well maintained and free of loose materials, e.g.
(Original instructions) ENGLISH Regularly clear the ventilation slots when working in dusty Voltage drops conditions. If it should become necessary to clean the Inrush currents cause short-time voltage drops. slots, remember to unplug the tool first. Under unfavourable power supply conditions, other Always store cutting discs well-protected and in a dry equipment may be affected.
(Original instructions) ENGLISH Replace the cutting disc (J). Make sure that the new disc Setting the clamping position (fig. 5) is placed onto the spacer (R) in the correct rotational The clamping position can be set to match the cutting disc. direction.
(Original instructions) ENGLISH Maximum cutting capacity Transporting (fig. 1) Note: Capacity shown on chart assumes no wheel wear and The tool is equipped with a lock chain (A) which locks the optimum fence position. tool in closed-down position for carrying. Warning: Ensure that the tool is switched off and disconnected from the mains supply before transporting.
(Original instructions) ENGLISH Repairs Technical data To assure product SAFETY and RELIABILITY, repairs, CS355 maintenance and adjustment should be performed by (Type1) authorized service centers or other qualified service Voltage organizations, always using identical replacement parts. Power Input 2,300 Lubrication 3,800 Closed-type, grease-sealed ball bearings are used throughout.
The guarantee is valid within the territories of the Member States of the European Union and the European Free Trade Area. CS355 If a Black & Decker product becomes defective due to faulty Black & Decker declares that these products described under materials, workmanship or lack of conformity, within 24 "technical data"...
ENGLISH Do not forget to register your product! www.blackanddecker.co.uk/productregistration Register your product online at www.blackanddecker.co.uk/productregistration or send your name, surname and product code to Black & Decker in your country...
Australia Black & Decker (Australia) Pty. Ltd. Tel. 03-8720 5100 20 Fletcher Road, Mooroolbark, Fax 03-9727 5940 Victoria, 3138 New Zealand Black & Decker Tel. +64 9 259 1133 5 Te Apunga Place Fax +64 9 259 1122 Mt Wellington Auckland 1060 United Kingdom Black &...