Radio Installation - THUNDER TIGER Piper J-3 Cub Assembly Manual

RADIO INSTALLATION

Install the rudder push rod using the same steps as for the elevator.
(Photos 81, 82, and 83)
Photo 81
Photo 82
Photo 83
Using a piece of the excess wire bend an extension for the on-off
switch. (Photo 84)
Photo 84
Drill a small hole through the fuselage in line with the switch.
Insert the extension wire through the fuselage and place in the switch.
Using needle nose pliers bend the wire to prevent it from coming
loose. (Photos 85 & 86)
Photo 85
Photo 86
Measure the cowl for the engine to be used and trim the cowling
to fit your particular engine. Cut all the inlets along the molded lines.
(Photo 87)
Photo 87
18