Advertisement

Quick Links

Assembly Manual
No.5126
Specifications
Length:27-5/32" (690mm)
Beam:7-9/32" (185mm)
Height:7-3/32" (180mm)
Weight:2.7 Ib (1210g)
This kit is guaranteed to be free from defects in material and workmanship at the date of purchase.
It does not cover any damage caused by use or modification. The warranty does not extend
beyond the product itself and is limited only to the original cost. By the act of using this
the user accepts all resulting in liability for damage caused by the product. If the buyer is not
prepared to accept this liability, it can be returned new and unused to the place of purchase for a
refund.
Notice: Adult Supervision Required
This is not a toy.
Running
Read through this book completely and become familiar with this boat.
completeness and damage. Browse www.thundertiger.com for more information or customer
service if you encounter any problem.
Warranty
this product requires adult supervision.
Off-shore Cataraman
1
product
Inspect all parts for
JJ6155
,

Advertisement

Table of Contents
loading

Summary of Contents for THUNDER TIGER Desperago Jr. 5126

  • Page 1 Off-shore Cataraman Assembly Manual No.5126 Specifications Length:27-5/32" (690mm) Beam:7-9/32" (185mm) Height:7-3/32" (180mm) Weight:2.7 Ib (1210g) Warranty This kit is guaranteed to be free from defects in material and workmanship at the date of purchase. It does not cover any damage caused by use or modification. The warranty does not extend beyond the product itself and is limited only to the original cost.
  • Page 2: Table Of Contents

    Wear safety glasses is strongly recommended as spinning propeller may throw loose material such as sand or gravel into your face. ITEMS NEEDED FOR COMPLETION Radio Radio Conversion Kit Thunder Tiger COUGAR P2 2CH (110V / 2P w/12PCS Ni-MH 1.2V radio is recommended. 1000mAh Batteries) No.2970 110V/2P No.2970...
  • Page 3: Quick-Start Guide

    QUICK-START Quick start Guide Note: Before running the Desperado JR. ,review this quick-start guide and the instruction manual . 2.Charge the Li-po battery. ( Lipo battery and charger 5.Connect the charged Li-po battery to the ESC, are not included. The special tone 1 2 3 , 3 short beep then a long beep tone are emitted.
  • Page 4: Parts Drawings

    PAR TS DRAWINGS PJ6308G Hull (Green) PJ6309G Hatch Cover (Green) PJ6308L Hull (Blue) PJ6309L Hatch Cover (Blue) Hull (1) Waterproof Hatch Cover(1) Spacer (L/1) Spacer (R/1) Plug (1) Boot (1) PJ6312 Strut PJ6313 Flex Shaft 2x5mm Handle (1) Wood Screw (1) Flex Shaft Tube (1) Strut (1) 2x8mm...
  • Page 5 A TS DRAWINGS PJ6311 Prop Shaft PJ6190 Antenna Mount Prop Shaft (1) Washer (1) Prop Drive Collar (1) Antenna Mount (1) M1.5 Hex Wrench (1) Hex Wrench (1) 4-Way Wrench (1) 2x8mm Wood Screw (2) Antenna Tube (1) 3x2mm 4x3mm Setscrew (1) Locknut (1) Setscrew (2) PJ6303 Motor Mount...
  • Page 6: Assembly

    ASSEMBLY 1.Locate two stands and beams. Assemble the stand 4.Install a mini servo in place as shown with two as illustrated. Locate the foam tapes, then apply on 3x6mm self-tapping screws. Adjust the clevis and the top side of the front and the rear stand, this is to make sure the servo and water rudder are in the protect the bottom surface of the hull.
  • Page 7: Radio

    RADIO Make sure the propeller rotates counter-clockwise, 10.The Desperado JR. OBL can run at full power if not then switch any two of the wires of the speed for about minutes and top speed may brushless motor to the connectors of controller. reach 22mile/hr if using the suggested 2200mAh Lipo Battery (No.2814).
  • Page 8: Adjustment

    ADJUSTMENT RADIO CHECK First remove any flashing on the propeller then use quality propeller balancer to do the balancing. Sharpen the leading edge of propeller will have better performance and get less prop walk to the right. Congratulations! Now you are ready to test run your boat! Switch on the radio and make sure the propeller will not rotate when the trigger is in neutral RUNNING THE...
  • Page 9: Maintenance

    MAINTENANCE MAINTENANCE Race with other boats. 1.Well exam the boat completely and make sure Basically you need to dry and clean the boat after all screws are fastened firmly, all wires are well running, specially if you would store the boat for connected, all water tubes are working smoothly a period of time.
  • Page 10: Motor

    MOTOR No.2375 OBL 29/19-15M...
  • Page 11: Speed Controller

    SPEED CONTROLLER ELECTRIC SPEED CONTROLLER FOR BRUSHLESS MOTOR IMPORTANT! Please center all the trim knobs in the netural position and calibrate the throttle range of your transmitter before boating. Always transmitter power on first RX last. (pull the trigger if pis tol ra dio is used). If there is an alert tone "beep-beep-beep-beep..", That means the controller does not recognize the high point.
  • Page 12: Speed Controller

    SPEED CONTROLLER...

Table of Contents