THUNDER TIGER Piper J-3 Cub Assembly Manual page 17

Install the other end of the throttle push rod in the EZ connector.
Trim off any excess wire (Photo 75).
Photo 75
Using a hobby knife carefully cut away the covering over the ele-
vator and rudder push-rod exits at the rear of the fuselage (Photo 76).
Photo 76
Install one push rod with the threaded end first through the fuse-
lage and exiting at the elevator exit slot. Locate a clevis and thread it
onto the threaded end at least 20 turns. Snap the clevis onto the con-
trol horn at the 3rd hole from the bottom (Photo 77).
Photo 77
RADIO INSTALLATION
Mark the other end of the push rod where the "Z" bend is to be
located (Photo 78).
Photo 78
Using "Z" Bend Pliers bend the push rod at the location marked
(Photo 79).
Photo 79
Insert the "Z" bend into the servo horn. Install the servo horn on
the servo (Photo 80).
Photo 80
17