THUNDER TIGER Piper J-3 Cub Assembly Manual page 13

Temporarily install the horizontal and vertical stabilizers (in that
order). Using a felt tip pen mark the fuselage location on both the
horizontal and vertical stabilizers. (Photo 49)
Photo 49
Remove the horizontal and vertical stabilizers from the fuselage.
Using a hobby knife cut the covering along the marked lines being
careful not to cut in the wood which could result in structural failure.
(Photo 50)
Photo 50
Mount the wing to the fuselage. Using 30-45 minute epoxy, install
the horizontal and vertical stabilizers in position. Ensure that the hor-
izontal stabilizer is parallel with the wing and that the vertical stabiliz-
er is 90-degrees to the horizontal stabilizer. Set aside until cured.
Locate the tail wheel wire hole on the rudder. Cut a slot in the fuse-
lage for the tail wheel gear wire hinge. (Photo 51)
Photo 51
STABILIZER ASSEMBLY
Cut a slot on the leading edge of the rudder. Trial fit the tail wheel
gear wire to the rudder. Cut a notch in the leading edge of the rudder
to allow clearance for the elevator joiner wire (Photo 52)
Photo 52
Locate the hinges for the rudder and place a drop of oil on each
hinge joint. Using 10-20 minute epoxy apply epoxy to one side of the
hinges and install them into the rudder. Install the tail wheel gear wire
into the rudder at this time also using epoxy. Set aside until cured.
(Photo 53)
Photo 53
Apply 10-20 minute epoxy to the hinges and install the rudder and
tail wheel gear wire into the vertical stabilizer and fuselage respec-
tively. Press together as tightly as possible to ensure minimal gap
between the rudder and vertical stabilizer. Install the tail wheel
mounting plate as shown with 2 M3x8 wood screws. (Photo 54).
Photo 54
13