Connection Terminals - AEI HA-263K Owner's Manual

Thank you for choosing the HA-263 Alarm Control Panel to protect you and your property. Your
system is one of the most powerful and advanced alarm systems on the market today, designed
to provide you with years of reliable service.
This owner's manual covers the information on both installation and operation. It describes the
functions of the connection terminals, all the aspects of the feature programming and the
operation procedures in detail.
To get most from the system, we suggest that you take time to read through the manual to get
acquainted with all its features and the operating procedures.
AEI PROTECT - ON SYSTEMS LTD.
www.protect-on.com
2
PREFACE
CLEAR THE ALARM MEMORY
In the condition of there was alarm occurred. The zone LED of the alarmed zones flash as alarm
memory after the system is disarmed with [USER CODE] [#]. It is necessary to clear the alarm
memory in the system or in the individual partitions before the system can be re-armed in the
normal way.
To clear the alarm memory, key-in [USER CODE], press [ ], then [3] and validate with [#] key.
USER CODE
!
The zone LEDs with alarm memory are OFF showing that the alarm memory has been cleared.
!
The system or the partition keeps in disarmed mode.
!
The system or the partition is ready for re-arm.
PANIC BUTTON
At anytime, hold down any TWO key-buttons on the keypad simultaneously for more than three
seconds will trigger an alarm. This software alarm zone is considered as a 24 hour emergency
alarm and is indicated on zone 8.
ANY TWO KEY BUTTONS
CHECK THE FAULTY ZONE(S)
While the system or the individual partition is in disarmed condition. The owner can key-in the
following command to check out the faulty zones.
USER CODE
!
The zone LED of the faulty zones are ON.
!
Each display period is 30 seconds. At the end of the period, a beep will be generated, if any
key button is pressed within 5 seconds after the beep, a new period of 30 seconds begins.
!
The display period may be prolonged as many times as necessary.
!
The system resumes to normal operation 5 seconds after the beep if it is not prolonged.
!
The system does not allow to arm during faulty zone checking and the keypad is temporarily
disabled.
4
HA-263 HA-263
3 #
1 #
HA-263D (OPERATION)
27