Operation - AEI HA-263K Owner's Manual

INTRODUCTION
HA-263 is a high performance local alarm control panel designed for home and office protections.
It features simple to use and simple to set up the system with minimum programmings. All the
main features can be set up via the jumpers on the circuit board. Absolutely no learning is
required. It is an ideal system for both "Do-it-yourself" and professional users.
The HA-263 comes with 3 partitions, they are partition 1, partition 2 and the common partition.
Partitions 1 and 2 are independently controlled for arm-disarm just like two alarm control panels,
which give the maximum flexibility for user's convenience and protection arrangement. The
common partition consists of one lobby protection zone and one 24 hour protection zone. The 24
hour zone works all the time for emergency alarms, such as fire, panic etc.. The lobby protection
zone is armed while both partitions 1 and 2 are armed to give maximum protection; and it is
disarmed while one of the partitions is disarmed. This allows either partition to arm, while leaving
the lobby for access into the other partition.
The HA-263 is offered with two versions, the HA-263K is arm-disarm controlled with keyswitch for
simple operation. The HA-263D comes with a digital keypad for arm-disarm control with user
codes, which also offers some additional features via programming on keypad.
The system can also be controlled with keyswitches and digital keypads in mixed operation. The
combined number of keyswitches and digital keypads are 4 maximum in total.
The features of the 8 protection zones in the 3 partitions are as follows:
!
Partition 1
ZONE 1 --- Delay
ZONE 2 --- Instant
ZONE 3 --- Instant
!
Partition 2
ZONE 4 --- Delay
ZONE 5 --- Instant
ZONE 6 --- Instant
!
Common Partition
ZONE 7 --- Delay (Lobby)
ZONE 8 --- 24 Hour Instant
4
ARM THE SYSTEM FOR HOME MODE (FOR USER CODE 3 ONLY)
1) This function can only be done with User Code 3
2) The protection zones stored in memory will be bypassed when the system is armed for home
mode.
3) Enter User Code 3, press [HOME] and validate with [#] key.
USER CODE 3
!
2-beep confirms correct code entry, exit delay starts and EXIT/ARMED LED flashes.
!
The bypassed zone LEDs flash all the time to indicate that the zones are not protected
!
System will arm after exit delay expired. The appropriate partition LED and the EXIT/ARMED
LED are ON.
!
You are allowed to move about freely inside the premises that the protection zones are
bypassed.
NOTE: The User Code 1 or User Code 2 still can be used to disarm its specific partition while
the system is operating on HOME mode.
ARM THE SYSTEM FOR HOME MODE INSTANTLY
1) The system arms instantly without Exit Delay on HOME mode.
2) Enter User Code 3, press [HOME], enter [2] and validate with [#] key.
USER CODE 3
!
2-beep confirms correct code entry and arms instantly for HOME mode.
ARM THE SYSTEM WITH MANUALLY BYPASSED ZONE(S)
In some circumstances, making bypass to the protection zone(s) temporary may be required,
such as:
1) To bypass the faulty zone(s).
2) To bypass the zone(s) that is not the habitually bypassed zone(s) in memory.
3) User Code 1 can only make bypass to the protection zones in partition 1 excluding the
common zones.
4) User Code 2 can only make bypass to the protection zones in partition 2 excluding the
common zones.
4
HA-263 HA-263
HA-263D (OPERATION)
HOME #
(FOR USER CODE 3 ONLY)
HOME 2 #
.
25