Snap Disc Replacement; Door Handle Assembly - Quadra-Fire 27I-ACC Owner's Manual

C. Snap Disc Replacement
1. The snap disc bracket assembly is located on top of the
blower housing in the center. Figure 23.1.
2. Remove the 4 hex head bolts using a 5/32 Allen wrench
from the blower housing and pull the housing towards you.
3. Pull the snap disc and spade connectors up and out of
bracket as shown in Figure 23.2.
4. Using a Phillips head screw driver, remove the 2 screws
from the snap disc and then remove the snap disc from
the spade connectors. Replace with new snap disc and
re-connect to spade connectors.
5. Push the snap disc and spade connectors back inside
bracket and re-attach the bracket to the appliance.
6. Re-attached the blower housing to the appliance.
Snap Disc Location
Remove Bolts and Slide
Blower Assembly Out
Figure 23.1 Snap Disc Location
Figure 23.2
October 22, 2013
Snap Disc
D. Door Handle Assembly
1. Install washer on door handle shaft.
2. Slide door handle through door.
3. Install second washer(s) as shown in Figure 23.3.
4. Install key in groove.
5. Align groove in latch cam with key; slide latch cam over
shaft
6. Install locknut but do not overtighten, the handle needs
to move smoothly.
7. Install handle turning in a counter-clockwise motion to
desired location on door handle rod. Figure 23.4.
CAUTION! Do not overtighten lock nut. The door handle
needs to move smoothly.
Latch Cam
Locknut
Figure 23.3 - Door Handle for Arched Door
Latch Cam
Locknut
Spacing
Washers
Figure 23.4 - Door Handle for Rectangular Door
7046-191
Door Cross Section
(example)
Door Handle
Spacing
Washers
Square Key
Door Cross
Section
Door Handle Shaft
Square Key
Fiber Handle
27I-ACC
Spring
Handle
23