Snap Disc Replacement - Quadra-Fire VOYAGEUR GRAND VOYA-GRAND-MBK Owner's Manual

C. Blower Replacement
1. The grille on the blower access assembly is
hinged. Swing the grille downward to expose the 2
screws (Figure 25.1).
2. Remove the 2 screws from the blower access assembly
and slide assembly away from the appliance.
3. Disconnect the wires from the blower.
4. Remove the 2 screws from the hold down bracket and
pull the blower and bracket forward.
5. Remove the blower from the hold down bracket.
6. Remove the protection guards from each end of
the blower.
7. Re-install in reverse order. Be certain that the hold down
bracket's screws are completely seated in the grommets.
Insert the locating tab in the hold down bracket into the
placement slot.
f i r e - p a r t s . c o m
Blower Access
Assembly
Grille hinges
Hold Down
downward
Bracket
Remove Screws &
Pull Access Assembly
away from Insert
Figure 25.1
January 20, 2020
Placement Slot
Snap Disc Bracket
Blower Control Plate
Remove Screws from Hold Down
Bracket and Pull Blower Assembly
Forward. Do not Remove Blower from
the Hold Down Bracket
D. Snap Disc Replacement
1. The grille on the blower access assembly is
hinged. Swing the grille downward to expose the 2
screws (Figure 25.1).
2. Remove the 2 screws from the blower access
assembly and slide assembly away from the appliance
3. Locate the snap disc bracket assembly behind the
blower controls on the right side under the ash
lip (Figure 25.2).
4. Remove the 2 mounting screws in the blower control
bracket and slide assembly towards you.
5. Using a Phillips head screw driver, remove the 2
screws from the snap disc and lift the snap disc off
of the mounting bracket. Disconnect the wires and
replace with new snap disc and re-connect the wires.
6. Slide the blower control bracket back into position and
secure with the 2 mounting screws.
Figure 25.2 - Snap Disc Location
7075-208N
VOYAGEUR GRAND Insert ACC
Blower Controls & Snap
Disc Under Ash Lip
Snap Disc
25