Table of Contents
Advertisement
Chapter 5 Wireless LAN
The following table describes the labels in this screen.
Table 20 Network > Wireless LAN > Guest Wi-Fi
LABEL
Guest Wi-Fi
Name (SSID)
Pre-Shared Key
Apply
Cancel
5.4 MAC Filter Screen
The MAC filter screen allows you to configure the WAH7130 to give exclusive access to devices
(Allow) or exclude devices from accessing the WAH7130 (Deny). Every Ethernet device has a
unique MAC (Media Access Control) address. The MAC address is assigned at the factory and
consists of six pairs of hexadecimal characters, for example, 00:A0:C5:00:00:02. You need to know
the MAC address of the devices to configure this screen.
To change your WAH7130's MAC filter settings, click Network > Wireless LAN > MAC Filter. The
screen appears as shown.
Figure 25 Network > Wireless LAN > MAC Filter
The following table describes the labels in this menu.
Table 21 Network > Wireless LAN > MAC Filter
LABEL
MAC Address
Filter
Allowed MAC
Address
MAC Filter Summary
Set
46
DESCRIPTION
Select Enable to turn on the guest wireless network on the WAH7130. Otherwise, select
Disable to turn it off.
Enter a descriptive name for the guest wireless LAN using up to 32 printable characters.
The default security mode for guest Wi-Fi is WPA2-PSK.
Type a pre-shared key from 8 to 63 case-sensitive ASCII characters (including spaces and
symbols) or type a pre-shared key less than 64 case-sensitive HEX characters ("0-9", "A-
F") for data encryption.
Click Apply to save your changes back to the WAH7130.
Click Cancel to reload the previous configuration for this screen.
DESCRIPTION
Select to turn on (Enable) or off (Disable) MAC address filtering.
Enter the MAC addresses (in XX:XX:XX:XX:XX:XX format) of the wireless client to be allowed
access to the WAH7130. Click Add to create a new entry in the summary table.
This is the index number of the MAC address.
WAH7130 User's Guide
Advertisement
Table of Contents
