Table of Contents
Advertisement
8.2 General
Use this read-only screen to view the NAT status. Click Network > NAT to open the General
screen.
Figure 30 Network > NAT > General
The following table describes the labels in this screen.
Table 26 Network > NAT > General
LABEL
Network Address
Translation (NAT)
Apply
Cancel
8.3 Port Forwarding Screen
Use this screen to forward incoming service requests to the server(s) on your local network and set
a default server. You may enter a single port number or a range of port numbers to be forwarded,
and the local IP address of the desired server. The port number identifies a service; for example,
web service is on port 80 and FTP on port 21. In some cases, such as for unknown services or
where one server can support more than one service (for example both FTP and web service), it
might be better to specify a range of port numbers.
In addition to the servers for specified services, NAT supports a default server. A service request
that does not have a server explicitly designated for it is forwarded to the default server. If the
default is not defined, the service request is simply discarded.
Note: Many residential broadband ISP accounts do not allow you to run any server
processes (such as a Web or FTP server) from your location. Your ISP may
periodically check for servers and may suspend your account if it discovers any
active services at your location. If you are unsure, refer to your ISP.
Port forwarding allows you to define the local servers to which the incoming services will be
forwarded. To change your WAH7130's port forwarding settings, click Network > NAT > Port
Forwarding. The screen appears as shown.
Note: If you do not assign a Default Server, the WAH7130 discards all packets received
for ports that are not specified in this screen or remote management.
WAH7130 User's Guide
DESCRIPTION
Network Address Translation (NAT) allows the translation of an Internet protocol
address used within one network (for example a private IP address used in a local
network) to a different IP address known within another network (for example a public
IP address used on the Internet).
NAT is always enabled on the WAH7130.
Click Apply to save your changes back to the WAH7130.
Click Cancel to begin configuring this screen afresh.
Chapter 8 NAT
57
Advertisement
Table of Contents
