Table of Contents
Advertisement
Chapter 8 NAT
Figure 31 Network > NAT > Port Forwarding
The following table describes the labels in this screen.
Table 27 Network > NAT > Port Forwarding
LABEL
Default Server Setup
Default Server
Change to Server
Service Name
Service Protocol
Server IP Address
Port
#
Status
Name
Protocol
Port
Server IP Address
58
DESCRIPTION
In addition to the servers for specified services, NAT supports a default server. A default
server receives packets from ports that are not specified in the Port Forwarding
screen. You can decide whether you want to use the default server or specify a server
manually.
Select this to use the default server.
Select this and manually enter the server's IP address.
Select a pre-defined service from the drop-down list box. The pre-defined service port
number(s) and protocol will be displayed in the port forwarding summary table.
Otherwise, select User define to manually enter the port number(s) and select the IP
protocol.
Select the transport layer protocol supported by this virtual server. Choices are TCP,
UDP, or TCP_UDP.
If you have chosen a pre-defined service in the Service Name field, the protocol will be
configured automatically.
Enter the inside IP address of the virtual server here and click Add to add it in the port
forwarding summary table.
Enter the service port number(s).
If you have chosen a pre-defined service in the Service Name field, the port number
will be configured automatically.
This is the number of an individual port forwarding server entry.
This icon is turned on when the rule is enabled.
This field displays a name to identify this rule.
This is the transport layer protocol used for the service.
This field displays the port number(s) that identifies a service.
This field displays the inside IP address of the server.
WAH7130 User's Guide
Advertisement
Table of Contents
