Tires; Wheels; Muffler/Spark Arrester; Muffler/Spark Arrester - Arctic Cat 366 2010 Operator's Manual

TIRES

! WARNING
Always use the size and type of
tires as specified. Refer to the Spec-
ifications chart for proper tire infla-
tion pressure, and always maintain
proper tire inflation pressure.
Tire Tread Condition
The use of worn-out tires on an ATV is
very dangerous. A tire is considered to
be worn out when the depth of the tread
is less than 3 mm (1/8 in.). Be sure to
replace the tires before reaching this
minimum specification.
! WARNING
The use of worn-out tires can be
dangerous and can increase the
risk of an accident.
Tire Replacement
The ATV has low-pressure tubeless
tires. Air is sealed by the contact sur-
faces of the inner wheel rim and the tire
bead. If either the inner wheel rim or
tire bead is damaged, air may leak. Be
extremely careful not to damage these
areas when replacing tires.
It is very important to use the proper
tools when repairing or replacing tires
to prevent damage to the tire bead or
wheel rims. If proper tools and related
items are not available, have this main-
tenance performed by an authorized
Arctic Cat ATV dealer or a qualified
tire repair station.
72
CAUTION
When breaking the tire bead loose
from the wheel, be extremely care-
ful not to damage the inner wheel
surface or the tire bead.
! WARNING
Use only Arctic Cat approved tires
when replacing tires. Failure to do
so could result in unstable ATV
operation.
Tubeless Tire Repair
Should a leak or flat tire occur due to a
puncture, the tire may be repaired
using a plug-type repair. If the damage
is from a cut or if the puncture cannot
be repaired using a plug, the tire must
be replaced. When operating the ATV
in areas where transportation or service
facilities are not readily available, it is
strongly recommended to carry a plug-
type repair kit and a tire pump along.

WHEELS

1. Park the ATV on level ground and
0732-649
engage the brake lever lock.
2. Loosen the lug nuts on the wheel
to be removed.
3. Elevate the ATV.
4. Remove the lug nuts.
5. Remove the wheel.
6. Install the wheel and install the lug
nuts.
7. Tighten the nuts in a crisscross
pattern to 40 ft-lb.
8. Remove the jack.
MUFFLER/SPARK
ARRESTER
The muffler has a spark arrester which
must be periodically cleaned. At the
intervals shown in the Maintenance
Schedule, clean the spark arrester using
the following procedure.