Erase Memory - Siemens RF30-EM Configuration Manual

Erase memory

12 Erase memory
28
Siemens AG
In cases where the RF30-EM is moved to another door (with new users), old
cards/codes should remain. The best way to ensure this is to erase the memory.
1. Remove the RF30-EM from the door.
2. Press and hold the reset button on the back of the RF30-EM for at least 2
seconds.
 The buzzer sounds a confirm tune.

Fig. 5 Reset button on the back
3. Press 112186 .
 The buzzer sounds a confirm tune.
 The buzzer sounds a warning tone to alert that you are about to erase the
memory.

4. Press 112186 .
 The buzzer sounds a confirm tune.

 The memory is erased.
 After approximately eight seconds the RF30-EM re-starts.
 The RF30-EM is in Stand-alone mode with the following default settings:
Administrator code: 112233
–
The Administrator code can also be used for unlocking the door.
–
All memory locations are empty.
–
Buzzer on.
–
04.2010