Change Administrator Code; Present Administrator Code Is Known - Siemens RF30-EM Configuration Manual

8

Change Administrator code

8.1

Present Administrator code is known

Siemens AG
NOTE

The Administrator code cannot be the same as the code 112186 to erase the memory.
See section 12 Erase memory.

If you are in administrator mode and don't press a key the device will automatically leave the
administrator mode after 30 seconds.
RF30-EM is delivered with the default Administrator code set as 112233.
1. Press B.

2. Enter the 6-digit Administrator code.

3. Press A27.
 The buzzer sounds a confirm tune.

4. Enter a new 6-digit Administrator code.
 The buzzer sounds a confirm tune.
5. Verify by entering the same Administrator code again.
 RF30-EM exits at the Administrator mode.

6. Make a note of the Administrator code.
Change Administrator code
04.2010
13