Service Mode; Check Signal Strength - A30; Check Link Reliability - A31; Reboot The Rf30-Em - A32 - Siemens RF30-EM Configuration Manual

System mode
9.2

Service mode

9.2.1

Check signal strength - A30

9.2.2 Check link reliability – A31
9.2.3 Reboot the RF30-EM – A32
9.2.4 Reconnect the network – A34
16
Siemens AG
1. To enter the service mode quickly press key B followed by a long press on
key B and wait until the buzzer confirm.
2. Enter the 6-digit Administrator code
 The commands A30, A31, A32 or A34 can then be performed.
3. To leave this mode press B .
The A30 command displays the signal strength. It will proceed for 5 minutes or until
a key press or card use. Note that although the green LED lit the command A31
should be performed to confirm a reliable data transmission.
LED
The command A31 displays the reliability of the data transmission. It will proceed
for 5 minutes or until a key press or card use.
Buzzer
Continuous tones.
Non continuous
tones.
Error tone.
The command A32 performs a reboot of the firmware in the RF30-EM.
The command A34 should be performed if e g a router has been added to the sys-
tem. The system tries to reconnect the RF30-EM to the Segment Controller.
Description
Signal strength excellent.
Signal strength sufficient.
Signal strength OK.
Recommendation

Relocate the router.
Signal strength bad.

Relocate the router.
Description
Link reliability OK. Sending and receiving messages.
One or more messages lost.
Recommendation

Relocate the router.
Link unreliability. Messaging took more then 0.7 s.

Relocate the router.
04.2010