Adding A Card By Entering Its Number - Siemens RF30-EM Configuration Manual

Stand-alone mode

11.1.2 Adding a card by entering its number

22
Siemens AG
NOTE
If you have entered the wrong Axx command (e g in step 3 below) you can abort the command and
exit to Administrator mode by pressing A again.
1. Press B .

2. Enter the 6-digit Administrator code. See section 8 Change Administrator
code.

3. Press A03 .
 The buzzer sounds a confirm tune.

 If the memory is full, the buzzer will sound an error tune and return to
Administrator mode.

4. Enter the last 8-digits of the card number on the keypad.
 The buzzer sounds a confirm tune.
5. Add the next card, if required.
04.2010