Command Overview - Siemens RF30-EM Configuration Manual

Command overview

14 Command overview
Command
Change Administrator code
Change Administrator
code
(Present Administrator
code is known)
Change Administrator
code
(Present Administrator
code is not known)
System mode
Activate System mode
Service mode
Enter Service mode

Check signal strength

Check link reliability

Reboot unit

Reconnect network
Leave Service mode
Normal mode
Check status
Stand-alone mode
Adding a card by reading it Press B.
Adding a card by entering
its number
Log on contiguous series
of cards
Cancel a card by reading it Press B.
Cancel a card by entering
its number
Enter Group code
Change group code
Delete Group code
30
Siemens AG
1. 2.
Press B. Enter the
6-digit Admin-
istrator code.
Remove the Press the
RF30-EM reset button
from the door. on the back of
the RF30-EM.
Press B. Enter the
6-digit Admin-
istrator code.
Press quickly Press long on
on B. B
Press A30
Press A31
Press A32
Press A34
Press B.
Press 0 for LEDs dis-
two seconds. plays status
Green LED =
OK
Enter the
6-digit Admin-
istrator code.
Press B. Enter the
6-digit Admin-
istrator code.
Press B. Enter the
6-digit Admin-
istrator code.
Enter the
6-digit Admin-
istrator code.
Press B. Enter the
6-digit Admin-
istrator code.
Press B. Enter the
6-digit Admin-
istrator code.
Press B. Enter the
6-digit Admin-
istrator code.
3. 4.
Press A27. Enter a new
6-digit Admin-
istrator code.
Enter the Verify by
desired 6-digit entering the
Administrator same Admin-
code. istrator code
again.
Enter A80. Enter the
4-digit Seg-
ment ID.
Buzzer Enter the
sounds 6-digit Admin-
istrator code.
Otherwise se
section 7.7
LED status
when
connecting
Press A01. Present the
card at the
RF30-EM.
Press A03. Enter the card
number on
the keypad.
Press A04. Enter the card
number of the
first card (last
8-digit) in the
series.
Press A14. Present the
card at the
RF30-EM.
Press A16. Enter the card
number on
the keypad.
Press A21. Enter the
desired 1-digit
group number
(1-4).
Press A21. Enter the
desired 1-digit
group number
(1-4)
5. 6.
Verify by Make a note
entering the of the Admin-
same Admin- istrator code.
istrator code
again.
Make a note
of the Admin-
istrator code.
Enter the 2- Enter the
digit Address. 8-digit Instal-
(01 - 32) lation ID.
Use com-
mand A30,
A31, A32 or
A34.
Enter the card
number of the
last card (last
8-digit) in the
series.
Enter the
desired 4-digit
Group code.
Enter 0000.
7.
Press A.
04.2010