Present Administrator Code Is Not Known - Siemens RF30-EM Configuration Manual

Change Administrator code
8.2

Present Administrator code is not known

14
Siemens AG
NOTE

The Administrator code cannot be the same as the code 112186 to erase the memory.
See section 12 Erase memory.

If you are in administrator mode and don't press a key the device will automatically leave the
administrator mode after 30 seconds.
1. Remove the RF30-EM from the door.
2. Quickly press the reset button on the back of the RF30-EM.
Fig. 2 Reset button on the back
 The buzzer sounds a confirm tune.

3. Enter the desired 6-digit Administrator code.
 The buzzer sounds a confirm tune.
4. Verify by entering the same Administrator code again.
 The buzzer sounds a confirm tune.
 If the second input doesn't match the first input the buzzer will sound a error
tone and the Administrator code will not be changed.
5. Make a note of the Administrator code.
04.2010