Troubleshooting - Gtech HT01 Safety And Instruction Manual

Troubleshooting

PROBLEM
Trimmer fails to operate
Cutting blade
excessivley hot
Cutting time low
Blade will not move
Do not hold switch on
when blade is jammed
Battery not charging
If the product needs to be repaired or replaced only use parts which are approved
by the manufacturer.
Should you experience any problems please do not return the product to the shop.
For any help and assistance please contact the customer support helpline:
01905 345891
Tel:
helpline 01905 345891 email support@greytechnology.co.uk web www.gtechonline.co.uk
HT01_UKManual2010v3.indd 13
POSSIBLE REASON
1. Battery flat
2. Cord not connected to battery pack
3. Faulty switch
1. Lack of lubrication
2. Blade damaged
3. Blade blunt
1. Battery not fully charged
2. Blade needs lubrication
3. Overloaded motor
4. Battery damaged or not holding charge
1. Battery flat
2. Blade teeth jammed or damaged
3. Blade corroded or seized
1. Charger not well connected to
battery pack.
2. Charger not fully pushed into
mains socket.
3. Mains socket not switched on
4. Defective mains socket, cable,
or charger
5. Charger faulty
support@greytechnology.co.uk
email:
POSSIBLE SOLUTION
1. Recharge battery
2. Check connection of cord
3. Switch in handle will 'click' if
operating properly
1. Clean and lubricate blade
2. Replace blade
3. Replace blade
1. Recharge battery
2. Clean and lubricate blade
3. Use lighter cutting action
4. Replace battery
1. Recharge battery
2. Remove obstructions from the
blade (switch tool off!)
3. Replace blade
1. Check charger plug is well
connected to battery pack
2. Push the charger fully into
mains socket
3. Switch on mains socket
4. Consult a qualified electrician
to check the socket. Contact
customer service centre or dealer.
5. Charger should feel warm
when charging correctly.
13
25/03/2010 10:02