Battery Charging And Recharging - Gtech HT01 Safety And Instruction Manual

Battery charging & recharging
WARNING: if the battery is damaged in any way do not attempt to charge it and
replace it immediately.
Before use check the power supply and charger cables for signs of damage or
ageing. A damaged charger cable can increase risk of fire or electric shock.
The battery has to be removed from the product to charge it.
To disconnect the battery pack, grip the battery connector and slide it off the battery pack.
Connect the charging jack into the socket on the battery pack.
Plug the charger into a suitable electrical socket and switch on.
From flat the battery requires 15 hours to fully charge.
There is NO indicator to show when the battery is charged. Charge for 15 hours to ensure a full
charged battery.
Note: the battery will not be damaged if charged for longer than 15 hours but should not be
charged for longer than 24 hours.
Once the battery is fully charged switch off the charger at the mains socket, remove the charging
jack form the battery pack, and unplug the charger from the mains socket.
WARNING: do not pull the charger by the cord.
WARNING: ensure the start switches are not in the on position before
reconnecting the battery to the product.
Push the battery connector onto the battery pack until it securely locates into place.
WARNING: only use the charger provided with the product. Using any other
charger may damage the product and the battery.
Only use replacement batteries as supplied by the manufacturer.
Spare and replacement batteries can be purchased from Grey Technology
Tel 01905 345891 or online at www.gtechonline.co.uk
7
helpline 01905 345891 email support@greytechnology.co.uk web www.gtechonline.co.uk
HT01_UKManual2010v3.indd 7 25/03/2010 10:02