Assembly; Fitting The Loop Handle; Assembling And Dismantling The Two-Piece Shaft - Husqvarna 129c Operator's Manual

Fitting the loop handle

• Clip the loop handle onto the shaft. Note that the loop
handle must be fitted between the arrows on the shaft.
• Fit the bolt, securing plate and wing nut as shown in
the diagram. Tighten the wing nut.
Assembling and dismantling the
two-piece shaft
(129LK)

Assembly:

• Loosen the coupling by turning the knob.
• Align the tab of the attachment (A) with the arrow on
the coupling (B).
B
• Push the attachment into the coupling until the
attachment snaps into place.
10 – English
ASSEMBLY
A
• Before using the unit, tighten the knob securely.
Dismantling:
• Loosen the coupling by turning the knob (at least 3
times).
• Push and hold the button (C). While securely holding
the engine end, pull the attachment straight out of the
coupling.
C