Connecting The Lines - Hangar 9 PT-19 CL Assembly Manual


Step 2
Pass the strap through the loop so you can insert your hand
through so that in the event you accidentally release the
handle while flying your model, it will not free-flight away
and do anyone any harm. You will only damage the model.
Hangar 9 PT-19 CL Assembly Manual

Connecting the Lines

Required Parts
• Assembled airframe • Control handle
• Assembled control line • Control line clip (4)

Step 1
Attach the control line clip to the leadout wires from
the handle.

Step 2
Attach the control line cables to the clips. This joins the
handle to the control line cables.

Step 3
Repeat Steps 1 and 2 to connect the control line cables to
the leadout wires at the aircraft.
Hint: When disconnecting the control line cables,
disconnect one connector from the leadout wire at
the aircraft, and one from the control line cable. This
will make it easy to connect the cables in their original
orientation. Connecting them in reverse may result in
slight trim changes to your aircraft.
Hint: Use a 4-40 hex wrench to locate the locking
screw on the moveable leadout guide inside the left
wing tip. Make sure the leadout guide is slid to the
forward (towards the front of the wing) position and
tightened in place. This is the proper starting point for
the adjustable leadout guide.
17