Hangar 9 PT-19 CL Assembly Manual page 11


Step 2
Use a file to make a flat spot on opposite sides of the wire
pushrod end. The pusheod setscrews will rest on these flat
areas making a more secure connection between the wire
pushrod end and the carbon pushrod.

Step 3
Slide the wire pushrod end in the carbon pushrod. Use two
3mm setscrews and the included hex wrench to secure the
end in the carbon pushrod.
Hangar 9 PT-19 CL Assembly Manual
Important: Make sure to use threadlock on the
setscrews to prevent them from vibrating loose.

Step 4
Slide the wire end of the pushrod into the opening in the top
of the wing.

Step 5
Insert the end of the wire into the center hole (or middle)
of the bellcrank inside the wing. Rotate the pushrod to
completely join the wire to the bellcrank.

Step 6
Thread the 3mm nut onto the threaded fitting of the elevator
pushrod. Thread the clevis onto the end at this time as well.
11