Prepare The Machine; Preparing To Work - Stiga SBL 260 H Operator's Manual

6
EN

4. PREPARE THE MACHINE

The machine can be used as both a blower and
a vacuum collector; for both of these uses it is
necessary to correctly arrange the appropriate
accessories included with the equipment.
WARNING!
ing the assembly should be done on a flat and
stable surface, with enough space for moving
the machine and its packaging, always mak-
ing use of suitable equipment.
Disposal of the packaging should be done in
accordance with the local regulations in force.
1. USE AS A BLOWER (Fig. 1)
– Remove the screw (1) and its washers (2).
– Align the first blower tube compartment (3)
with the protrusion (4) of the air outlet, push
the tube and turn it 90° clockwise, in order to
permanently fix it in place.
– Fix the tube (3) to the air outlet using the
screw (1) and its washers (2).
– Align the second blower tube compartment (5)
with the protrusion (6) of the first tube, push
the tube and turn it 90° clockwise, in order to
permanently fix it in place.
NOTE
assembled when the flat part of the blower chute
is pointed towards the ground.

5. PREPARING TO WORK

CHECKING THE MACHINE
Before starting work please:
– check that all the screws on the machine are
tightly fastened;
– when used as a vacuum collector, make sure
the bag is integral, well-closed and that the
zipper works correctly;
– check that the air filter is clean;
– check that the handgrips are well fastened;
– prepare accessories according to the type of
work (as blower or vacuum collector) and
make sure they are correctly mounted;
– fill will fuel as indicated below.
Unpacking and complet-
The machine is correctly
PREPARE THE MACHINE - PREPARING TO WORK
2. USE AS A VACUUM COLLECTOR (Fig. 2)
– Remove the screw (1) and its washers (2).
– Align the housing of the tube fitting bag (3)
with the protrusion (4) of the air outlet, push
the tube and turn it 90° anticlockwise, in order
to permanently fix it in place.
NOTE
assembled when the tube's terminal chute is
pointed downwards and to the left of the ope-
rator.
– Fix the tube (3) to the air outlet using the
screw (1) and its washers (2).
– Loosen the knob (5) and open the protection
grille (6).
– Align the first vacuum tube compartment (7)
with the protrusion (8) of the inlet, push the
tube and turn it 90° clockwise, in order to per-
manently fix it in place.
– Align the second vacuum tube compartment
(9) with the protrusion (10) of the first tube,
push the tube and turn it 90° clockwise, in or-
der to permanently fix it in place.
NOTE
assembled when the rounded part of the chute is
pointed towards the ground.
– Insert the tube fitting end chute (3) in the spe-
cific bag (11) and close the opening with the
supplied Velcro strap (12).
– Hang the bag over your shoulder and adjust
height using the strap.
PREPARING THE FUEL
This machine is fitted with a two-stroke engine
which requires a mixture of petrol and lubricating
oil.
IMPORTANT
damage the engine and invalidate the warranty.
IMPORTANT
oils to maintain high performance and guarantee
the duration of the mechanical parts over time.
The machine is correctly
The machine is correctly
Using petrol alone will
Only use quality fuels and