Husqvarna 50 Workshop Manual page 56

Downloaded from www.Manualslib.com
Check the small-end of the connecting rod. If seizure
marks or discolored spots are evident in the bearing seat,
the crankshaft must be replaced.
Assembly
Thoroughly clean all parts before assembly. Make sure
the crankcase half mating surfaces are clean and free of
all gasket material. Heat the bearing seat area of the
ignition (right) side crankcase half and install the crank-
shaft bearing. Make sure the bearing is fully seated.
Heat the bearing seat area of the drive (left) side crank-
case half and install the crankshaft bearing ensuring it is
fully seated.
manuals search engine