Husqvarna 50 Workshop Manual page 35

Assembly
Install the fuel tank vent using a drift the same diameter
as the vent tube. The remainder of assembly is the
reverse of disassembly.
The exposed length of the fuel tank hose
measured between the fuel tank and the carburetor
Carburetor
Removal
Remove the air filter and disconnect the fuel hose at
the carburetor. Remove the one screw retaining the air
filter mounting plate to the crankcase and the two
screws retaining the plate and carburetor to the intake
manifold.
Remove the air filter plate and carburetor with throttle
linkage and (if equipped) choke linkage.
Remove the two screws retaining the intake manifold to
the crankcase and remove the manifold. Separate and
clean the parts.
Downloaded from www.Manualslib.com
NOTE !
should be 115 mm (4 1/2 in.)
manuals search engine