Husqvarna 50 Workshop Manual page 21

Carefully pull the spark plug boot over the spring.
Assemble the starter to the saw and check for spark as
previously instructed in the Checking for Spark section.
Flywheel Removal
Remove the spark plug and thread the piston stop P/N
5025033-01 into the spark plug opening in the cylinder.
Make sure that the piston stop is threaded
completely into the cylinder.
Gently rotate the flywheel counterclockwise by hand until
the piston contacts the piston stop. Remove the flywheel
retaining nut and washer. The flywheel nut has right-
handed threads.
Thread the flywheel remounting device P/N 5052679-12
onto the end of the crankshaft. After the tool contacts
the flywheel, unthread the tool 1-1/2 turns so that an
approximate clearance of 2 mm (0.078 in.) exists
between the tool and the flywheel.
Downloaded from www.Manualslib.com
NOTE !
manuals search engine
6