Husqvarna 50 Workshop Manual page 20

Downloaded from www.Manualslib.com
6
If the ignition module is new, it will be necessary to install
a new spark plug connector spring on the high tension
lead. Before installing the connector spring, first correctly
route the high tension lead from the module to the spark
plug. If necessary, cut the high tension lead to the
correct length.
Using the assembly pliers P/N 5025006-01, make a
hole for the contact spring approximately 13 mm (1/2 in.)
from the end of the lead.
Push the high tension lead through the spark plug boot
until the lead extends out the other side.
Install the contact spring onto the end of the high tension
lead with the assembly pliers.
manuals search engine