Husqvarna 50 Workshop Manual page 16

Downloaded from www.Manualslib.com
To install the starter assembly on crankcase, first pull the
starter grip out approximately 15 cm (6 in.) then position
the housing against the crankcase.
pawls on the flywheel. Install and tighten the four starter
manuals search engine
Pull the starter cord up into the pulley notch and rotate
the pulley clockwise two turns.
Check that the starter pulley can be turned at least
one half of a turn further when the starter cord is
pulled to the end of rope travel.
Release the grip so that the pulley engages the starter
retaining screws.
NOTE !