Husqvarna 50 Workshop Manual page 52

Downloaded from www.Manualslib.com
12
Position the piston over the connecting rod with arrow on
the piston crown pointing towards the exhaust side. Align
the piston pin boss holes with the connecting rod pin hole
and install the pin. Carefully install the wrist pin clips
ensuring that the clips are fully seated in the retaining
grooves. Lubricate the piston and piston ring with oil.
A pin is located within the piston ring groove on the intake
side of the piston to prevent ring rotation. Make sure the
ends of the piston ring are on either side of the piston ring
retaining pin.
Using the piston/cylinder mounting set P/N 5025070-01,
compress the piston ring with the appropriate ring
compressor.
Carefully install the cylinder over the piston and ring.
Tighten the cylinder retaining screws in a cross pattern.
The remainder of reassembly is in the reverse order of
disassembly.
manuals search engine