Downloaded from
www.Manualslib.com
5
manuals search engine
Disassembly
Remove the four starter housing retaining screws and
remove the starter assembly from the crankcase.
If the starter rope is still under tension from the rewind
spring, pull the starter grip out approximately 30 cm (12
inches) and hold starter pulley. Pull a loop of starter rope
up between pulley and housing. On 50 and 50 Special
models, engage rope in pulley notch. On 51 and 55
models, pull rope up between any notched section in
pulley.
Carefully and slowly release the pulley to allow the
rewind spring to unwind. Remove pulley retaining screw
from the starter post and remove the pulley. Carefully
withdraw the recoil spring cassette. Clean all parts
before assembly.
Be very careful when removing and installing the
rewind spring. The rewind
dislodged from the spring cassette causing injuries.
Wear safety goggles for eye protection.
WARNING !
spring can become