Power Trim And Tilt Switch On Bottom Engine Cowling; Variable Trolling Rpm Switches - Yamaha F40F Owner's Manual

EMU26153
Power trim and tilt switch on bottom
engine cowling
The power trim and tilt switch is located on
the side of the bottom engine cowling. Press-
ing the switch "
motor up, and then tilts it up. Pressing the
switch " " (down) tilts the outboard motor
down and trims it down. When the switch is
released, the outboard motor will stop in its
current position.
For instructions on using the power trim and
tilt switch, see page 53.
EWM01030
WARNING
Use the power trim and tilt switch located
on the bottom engine cowling only when
the boat is at a complete stop with the en-
gine off. Attempting to use this switch
while the boat is moving could increase
the risk of falling overboard and could
distract the operator, increasing the risk
of collision with another boat or an obsta-
cle.
" (up) trims the outboard
1. Power trim and tilt switch
EMU30900

Variable trolling RPM switches

The trolling speed can be adjusted when the
outboard motor is trolling. Press the "
switch to increase the trolling speed and
press the " " switch to decrease the trolling
speed.
TIP:
The trolling speed changes approximately
●
50 r/min each time a switch is pressed.
If the trolling speed has been adjusted, the
●
engine returns to the normal trolling speed
when the engine is stopped and restarted
or when the engine speed exceeds ap-
proximately 3000 r/min.
For instructions on using the variable troll-
●
ing RPM switches, see page 49.
1. Variable trolling RPM switch
Components
1
ZMU06394
UP
DN
"
21