Operation - Blaupunkt BB5WH Owner's Manual

BB5WH
FM RADIO
Tuning The FM Radio
1. The standby indicator will light once connect the main unit to the main power. Press the ON/STANDBY
button to turn the unit on (the standby indicator will be off).
2. Press the SOURCE button repeatedly to switch the unit to the FM radio mode.
3. To launch the auto-searching, press and hold the SKIP/SEARCH DOWN button or SKIP/SEARCH UP button
several seconds and then release it.
4. Press the SKIP/SEARCH DOWN button or SKIP/SEARCH UP button to tune the radio stations manually.
5. Adjust the volume level to a comfortable listening level via pressing the VOL+/- buttons.
6. Press the ON/STANDBY button to turn off the unit.
NOTE:
The FM TELESCOPIC ANTENNA is directional. When you are receiving an FM broadcast, fully extend the
TELESCOPIC ANTENNA and rotate it for the best reception.
Storing Your Favorite Radio Station
1. Tune to your favorite station first; press the PROG/MEM/MODE button for storing the current station until
memory cell number flashes on the screen.
2. Use the STOP/CH- button or the PLAY/PAUSE/CH+ button to select the corresponding memory cell.
3. Confirm your selection by pressing the PROG/MEM/MODE button.
4. During radio playback, press the STOP/CH- button or the PLAY/PAUSE/CH+ button repeatedly to recall
the preset stations.

OPERATION

Load a Disc
1. Open the CD door by the Door open area.
2. Load a disc on the disc tray with the label side facing up.
3. Close the CD door.
Play a Disc (CD/MP3)
1. Press the ON/STANDBY button to turn the unit on (the standby indicator will be off).
2. Press the SOURCE button repeatedly to switch to CD mode.
3. Follow the steps above to load a disc.
4. The player begins reading disc immediately.
5. When the disc is successfully read, the playback will start from the first track automatically.
6. Press the PLAY/PAUSE/CH+ button once to halt music playback, press the button again to resume the
normal playback; press the STOP/CH- button to cease music playback.
External Memory Media Operation (USB)
1. Press the ON/STANDBY button to turn the unit on (the standby indicator will be off).
2. Insert an USB to the USB port.
3. Press the SOURCE button repeatedly to switch to USB mode.
4. When the inserted USB is detected and read, the first track will be played automatically.
5. Press the PLAY/PAUSE/CH+ button to pause or resume the playback.
6. Press the STOP/CH- button to cease the playback.
Skip Tracks and Search for a Specific Point to Play (CD/MP3/USB)
1. Press once the SKIP/SEARCH UP button in music play to skip to the next track; press once the
SKIP/SEARCH DOWN button in music play to go back to beginning of the current track, press the button
twice continuously to skip to the previous track.
2. Press and hold the SKIP/SEARCH UP button or the SKIP/SEARCH DOWN button in music play to search at
quick rate for a specific point to play.
3. Press the FOLDER/10+ button once in play to skip to the track 10 tracks ahead, twice to skip to the track 20
tracks ahead. You can reach the last track of the disc using this button.
8