Important Note - Blaupunkt BB5WH Owner's Manual

BB5WH
20. Please remove the power plug form the main power source or wall power source when not in use. When
plugged in to a power source, the system is in standby mode, so the power is not entirely cut off.
21. Replacement parts - When replacement parts are required, ensure that the service technician has used
replacement parts specified by the manufacturer or have the same characteristics as the original part.
Unauthorized substitutions may result in fire, electric shock or other hazards.
22. Mains fuses - For continued protection against fire hazard, use fuses only of the correct type and rating.
23. Do not turn up the volume while listening to a section with very low level inputs or no audio signals. If
you do, the speaker may be damaged when a peak level section is suddenly played.
24. The only means of completely disconnecting the product from the power supply is by removing the
power cord from the wall outlet or the product. The wall outlet or the power cord entry to the product
must remain freely accessible at all times while the product is in use.
25. Try to install the product near a wall socket or extension cord and shall be easily accessible.
26. The highest environmental temperature suitable for this product is 35°C.
27. ESD hints - If the product maybe reset or not reset to operation of control due to electrostatic discharge,
just switch off and reconnect again, or move the product to another location.
28. Battery
1). The batteries must not be exposed to excessive heat such as sunshine, fire or the like.
2). The batteries should be drawn to the environmental aspects of battery disposal.
3). Battery usage CAUTION-to prevent battery leakage which may result in body injuries, property
damage, or damage to the apparatus:
- Install all batteries correctly, + and as marked on the apparatus.
- Do not mix batteries (old and new or carbon and alkaline, etc.)
- Remove batteries when the unit is not used for a long time.
ERP2 (Energy Related Products) note
This product with ecodesign complies with the stage 2 requirements of Commission Regulation (EC) NO.
1275/2008 implementing Directive 2009/125/EC regard to standby and off mode electric power
consumption of electronic household and office equipment. After 60 minutes without any audio input, the
device will automatically switch into standby mode. Follow up the instruction manual to resume the
operation.

Important note:

This device is equipped with an energy saving mode: if no signal is given during 60 minutes the device will
switch automatically into standby mode in order to save energy (ERP 2 standard). Please note that low
volume setting in the audio source may be recognized as no audio signal : this will affect the capability of
signal detection from the device and can also originate an automatic switch into standby mode. If this
happens please reactivate the audio signal transmission or increase the volume setting on the audio source
player (MP3 player, etc.), in order to resume playback. Please contact the local service center if the problem
remains.
WARNING
This appliance is not intended for use by persons (including children) with reduced physical sensory or
mental capabilities, or lack of experience and knowledge, unless they have been given supervision or
instruction concerning use of the appliance by a person responsible for their safety. Children should be
supervised to ensure that they do not play with the appliance.
1. Never use the device unsupervised! Switch off the device whenever you are not using it, even if this only
for a short while.
2. The appliance is not intended to be operated by means of an external timer or separate remote control
system.
3. If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly
qualified persons in order to avoid a hazard.
4. Before operating this system, check the voltage of this system to see if it is identical to the voltage of your
local power supply.
4