New Balance 5K 5100 Owner's Manual page 8

STEP 3 – Handlebar Assembly
Lift the Handlebar Clamp on the top of the
Computer Tube. Position the Handlebar
Assembly in the "U" and close the Clamp.
Place the Computer Tube Cover over the
closed Clamp and Handlebar. Insert the
T-Knob and Long Sleeve and rotate it
clockwise to secure the Handlebar.
STEP 4 – Water Bottle Holder Assembly
Line up Water Bottle Holder and attach to the
Computer Tube by using the Phillips Bolts from
the fastener pack. Tightening them with the
Phillips Screwdriver provided.
You can place the water bottle in the holder at any time.
STEP 5 – Seat Assembly
a) Remove the Nuts and Washers from the bottom of the Seat. Attach Seat Post
Slider to the bottom of the Seat with Nuts and Washers removed at the beginning
of this step.
b) Slide the Seat Post Slider into the Seat Post and secure using the T-Knob, Short
Sleeve and Washer from the fastener pack. Make sure the T-Knob is threading
into the hole in the sliding plate inside the Seat Post Slider.
c) Slide the Seat Post into the rear of the Main
Frame by loosening the Height Adjustment
Knob (aligning the holes with the Adjustment
Knob). Once in position, and the Knob is in a
hole, turn the Height Adjustment Knob to
tighten it. Make sure the T-Knob and
Height Adjustment Knob are secure
before beginning exercises.
5a
seat
post
washers
seat
post
seat post slider
sliding
plate
nuts
washer
short sleeve
"T" knob
5b
handlebar
assembly
computer
tube
water
bottle
handlebar
computer
clamp
tube cover
long sleeve
"T" knob
bolts
water bottle
holder
"T" knob
seat
post
5c
height
adjustment
knob
main frame
assembly
7