Table of Contents
Advertisement
The update jumper for the KP4 (and KPL) is located on the right side of the keypad when facing front.
This is covered when a trim plate is installed. Note: The update pins on the KP4 are accessed from
the side when the keypad is not installed.
2
DVD
XM1
Source
KP4 Front View
KP4 Top View
KP4 Side View
CABLE
AM/FM
1
2
1
Jumpered
pins
COMPONENT GUIDE
Keypad Front Panel
OS UPDATE/RUN JUMPER -The pins are
1
jumpered when performing a firmware
update on the keypad, and removed
during normal operation.
OS UPDATE PORT - Used to update the
2
KP4 and KPL keypad operating system
firmware. If an update is released, it will
be available online through the
Document Center on
www.russound.com . Look in the
"Firmware and Downloads" section under
Multi-Zone product type. The Advanced
Programming Cable is available from
Russound, Part #2500-521065.
INSTALLER
15
Hide quick links:
Advertisement
Table of Contents
