Front Panel Connectors - Russound A2100 Installation Manual

FRONT PANEL CONNECTORS

1 2
3 4 5 6
4
7 8 9
Russound A2100 Installation Manual
1
Power Button: Power - the front panel switch will
manually switch the power on or off.
2
Power/Standby LED: On start-up, the first LED lights red
to show power on. When the amplifier goes into standby,
the LED will light amber. The LED will light green during
normal operation.
3
Line In: Analog stereo audio input for a single input
source. When in Bridge Mode, use the "L" audio input for the
input signal.
4
Line Out: A buffered line out is available to extend the
audio signal to additional amplifiers as needed.
5
Volume: Use this gain switch to attenuate the volume
level to meet the room's needs.
6
Output: The output switch has three positions, Bridge
(mono), 8Ω (stereo), 4Ω (stereo). The default setting is 8Ω.
7
Turn-On: There are three turn on-modes: always-on
(On) , audio sensing (Auto) and activated by the 12v Trigger
(Trigger). The default setting is On
8
12VDC Trigger: Turns on the A2100 when set to Trigger
mode and a 12VDC signal is received. The Trigger Out
provides 100mA 12VDC max to drive other 12V triggered
devices. When using Trigger mode, the front panel power
switch must be ON.
10
9
Speaker Out: Connect your loudspeaker(s) here. Up to
12ga AWG wire may be used.
10
AC Input: Use a 3-prong grounded IEC cord. The
locking connector may be engaged to prevent cords from
accidentaly dislodging in an equipment rack.