Snmp Access Control - Atlantis Land A02-RAV260-W54 User Manual

Both the user's Operating System and the relevant application must support UPnP in addition
to the router. Windows XP and Windows Me natively support UPnP (when the component is
installed), and Windows 98 users may install the Internet Connection Sharing client from
Windows XP in order to support UPnP. Windows 2000 does not support UPnP.
• Disable: Check to disable the router's UPnP functionality.
• Enable: Check to enable the router's UPnP functionality.
UPnP Port: Its default setting is 2800. It is highly recommended for users to use this port
value. If this value conflicts with other ports already being used you may wish to change the
port.

SNMP Access Control

SNMP V1 and V2
Read Community: Specify a name to be identified as the Read Community, and an P
address.
This community string will be checked against the string entered in the configuration file.
Once the string name is matched, user obtains this IP address will be able to view the data.
Write Community: Specify a name to be identified as the Write Community, and an IP
address.
This community string will be checked against the string entered in the configuration file.
Once the string name is matched, users from this IP address will be able to view and modify
the data.
Trap Community: Specify a name to be identified as the Trap Community, and an IP
address.
This community string will be checked against the string entered in the configuration file.
Once the string name is matched, users from this IP address will be sent SNMP Traps.
SNMP V3
Specify a name and password for authentication. And define the access right from identified
IP address. Once the authentication has succeeded, users from this IP address will be able
to view and modify the data.
SNMP Version: SNMPv2c and SNMPv3
SNMPv2c is the combination of the enhanced protocol features of SNMPv2 without the
SNMPv2 security. The "c" comes from the fact that SNMPv2c uses the SNMPv1 community
string paradigm for "security", but is widely accepted as the SNMPv2 standard. SNMPv3 is a
strong authentication mechanism, authorization with fine granularity for remote monitoring.
Traps supported: Cold Start, Authentication Failure.
The following MIBs are supported:
• RFC 1213 (MIB-II):
System group
Interfaces group
Address Translation group
IP group
ICMP group
TCP group
UDP group
EGP (not applicable)
Transmission
SNMP group
VoIPMaster 260W
98