Scan Mode; Broadcast Mode; Normal Mode; Mice And Trackballs With Macs - Network Technologies NTI UNIMUX UNIMUX-USBV-2 Installation And Operation Manual

2-port usb kvm switch unimux series

Hide thumbs Also See for NTI UNIMUX UNIMUX-USBV-2:

Table of Contents

NTI UNIMUX 2-PORT USB KVM SWITCH

Scan Mode

Scan Mode is indicated by a flashing CPU port LED. In Scan Mode the switch scans back and forth between ports making the

CPU connected to the port with the flashing LED active.

connected port becomes idle for the user selected time out period (default time is 5 seconds), the UNIMUX-USBV-2 will connect

to the other CPU port. See Command Mode section on page 7 for configuring the scan time out period.

NOTE: The keyboard and mouse must remain idle for the full scan time out period before the UNIMUX-USBV-2 will

connect to the other port.

(use with extreme caution)

Broadcast Mode allows the user to send keystrokes to all active CPUs. Broadcast Mode is indicated by illuminating the

CPU x LEDs in rapid alternating intervals . Broadcast Mode has some critical requirements:

Broadcast Mode must be OFF when booting any attached CPUs.

Broadcast Mode must be ON and the user must exit Command Mode for keystrokes to reach attached CPUs.

NOTE: The mouse is disabled leaving only the keyboard active during Broadcast Mode.

The UNIMUX-USBV-2 is in Normal Mode when only the LED for the active CPU is illuminated solid (not flashing as in Scan

Mode). When in Normal Mode, the user is controlling only the CPU to which the user is connected through the UNIMUX-USBV-2.

In Normal Mode the UNIMUX-USBV-2 will only switch between CPUs 1 and 2 when the user uses either keyboard control or

button control to do so.

The UNIMUX-USBV-2 can be configured to enable full functionality between mice and trackballs having two or more buttons and

USB MAC CPUs. By default, the ports on the UNIMUX-USBV-2 are configured for use with WINDOWS and SUN CPUs and

have no special translation for using multi-function mice and trackballs when a MAC CPU is connected. Using the commands in

Command Mode on page 7, either enable or disable this feature as needed for each port.

NOTE: Be sure to re-configure port for connection to a WINDOWS or SUN CPU if a MAC CPU is removed and a

WINDOWS or SUN CPU is then connected.

That connected port will remain active while in use. When the

Table of Contents