Atlantis Land A02-RA144-W300N User Manual page 56

The following table describes the labels in this screen.
PARAMETRES
ATM VC
Virtual Circuit ID
Status
VPI
VCI
ATM QoS Type
Cell Rate
Peak Cell Rate
Sustain Cell
Rate
Maximum Burst
Size
ENCAPSULATION
Encapsulation
PPPoA/PPPoE
Service Name
User Name
Password
VPI (Virtual Path Identifier) and VCI (Virtual Channel Identifier)
define a virtual circuit.
Activated or Deactivated
The valid range for the VPI is 0 to 255. Enter the VPI assigned
to you. This field may already be configured.
The valid range for the VCI is 32 to 65535. Enter the VCI
assigned to you. This field may already be configured.
Select CBR (Continuous Bit Rate) to specify fixed (always-on)
bandwidth for voice or data traffic. Select UBR (Unspecified Bit
Rate) for applications that are non-time sensitive, such as e-
mail. Select VBR (Variable Bit Rate) for bursty traffic and
bandwidth sharing with other applications.
VBR is not available on all models.
Cell rate configuration often helps eliminate traffic congestion
that slows transmission of real time data such as audio and
video connections.
Divide the DSL line rate (bps) by 424 (the size of an ATM cell) to
find the Peak Cell Rate (PCR). This is the maximum rate at
which the sender can send cells. Type the PCR here.
The Sustain Cell Rate (SCR) sets the average cell rate (long-
term) that can be transmitted. Type the SCR, which must be
less than the PCR.
Maximum Burst Size (MBS) refers to the maximum number of
cells that can be sent at the peak rate. Type the MBS, which is
less than 65535.
Select the method of encapsulation used by your ISP from the
drop-down list box.
(PPPoE only) Type the name of your PPPoE service here.
Enter the user name exactly as your ISP assigned. If assigned a
name in the form user@domain where domain identifies a
service name, then enter both components exactly as given.
A static IP address is a fixed IP that your ISP gives you. A
dynamic IP address is not fixed; the ISP assigns you a different
one each time you connect to the Internet. The Single User
Account feature can be used with either a dynamic or static IP
address.
A02-RA144-W300N
WebShare 144WN
DESCRIPTION
Pag. 46