Register Your Product; Appliance Description - STIEBEL ELTRON accelera 220 e Operation And Installation Manual

OPERATION

Register your product

11. Booster heater element information label
CAUTION
for use only in water
ATTENTION
pour l'utilisation dans l'eau
ATENCIÓN
se usa sólo para en agua
12. Appliance must be vertical for at least one hour before com-
missioning information label
WARNING / WARNUNG
The unit must remain in vertical position for at least
one hour before putting unit into operation.
Die Anlage muss min. 1 Stunde lang vor deren
Inbetriebnahme in senkrechter Position bleiben.
L'appareil doit être placé en position verticale
au moins une heure avant sa mise en route.
La unidad tiene que quedar en la posición vertical
al menos durante una hora antes de poner la unidad
en funcionamiento.
10 | Accelera® 220-300 E
3. Register your product
You must register this product within 90 days of pur-
chase on our web site in order to activate the standard
warranty or to be eligible for the extended warranty.
Go to our web site at
www.stiebel-eltron-usa.com and click on register
your product.
Before beginning the registration process, we suggest that
you gather the necessary information which will be as
follows:
1 Serial number on the type plate
Type, Example: Accelera 220 E (from the label that is on the
unit)
Number listed after "Nr."
Place of Purchase
315125-38055
Purchase Date
First & Last Name
Email address
Physical Address
Phone Number
Installation Date
If you have any questions concerning the registration process
or warranty options, please contact Stiebel Eltron USA direct-
ly at 800-582-8423.
4.

Appliance description

The appliance is designed for indoor installation. The appliance
recirculates ambient air and does not require outdoor air. The
appliance extracts heat from the ambient air. This heat is utilized
to heat the water in the DHW tank with added electric power. The
amount of electric energy and time required to heat-up the DHW
depends on the temperature and humidity of the ambient air.
This heat extraction results in a drop in the ambient temperature
inside the installation room by between 2 °F (1 °C) and 5.5 °F (3 °C).
The appliance also extracts moisture from the air, which turns into
condensate. The condensate is drained from the appliance via the
condensate drain.
When a hot water draw-off point is opened, the hot DHW is pushed
out of the appliance by the in-fl ow of cold DHW.
To protect against corrosion, the inside of the DHW tank is coated
with special enamel and is additionally equipped with an im-
pressed current anode.
www.stiebel-eltron-usa.com