Netopia R7200 User Reference Manual page 87

5. If your ISP uses numbered (interface-based) routing, select Local WAN IP Address and enter the local WAN
address your ISP gave you. Then select Local WAN IP Mask and enter the WAN subnet mask of the remote
site you will connect to.
The default address is 0.0.0.0, which allows for dynamic addressing, meaning that your ISP assigns an
address via DHCP each time you connect. However, if you want to use static addressing, enter a specific
address.
Address Translation Enabled:
IP Addressing...
Local WAN IP Address:
Local WAN IP Mask:
Filter Set...
Remove Filter Set
Receive RIP:
Enter an IP address in decimal and dot form (xxx.xxx.xxx.xxx).
Configure IP requirements for a remote network connection here.
Note: The Local WAN IP Address is displayed for numbered and/or NAT profiles. The Local WAN IP Mask is
displayed for numbered profiles. The Remote IP Address and Remote IP Mask are displayed for
unnumbered profiles.
Address Translation Enabled:
IP Addressing...
Remote IP Address:
Remote IP Mask:
Filter Set...
Remove Filter Set
Receive RIP:
Transmit RIP:
Return/Enter to select <among/between> ...
Configure IP requirements for a remote network connection here.
IP Setup and Network Address Translation 10-5
IP Profile Parameters
Yes
Numbered
0.0.0.0
0.0.0.0
Off
IP Profile Parameters
Yes
Unnumbered
0.0.0.0
0.0.0.0
Off
Off