Soil Settler Soil Removal System; Start-Up Guide; Using Your New Dishwasher - Kenmore 665.1772 Series Use & Care Manual

The Soil Settler soil removal system cleans by spraying a
mixture of hot, clean water and detergent against soiled
dishes.
To clean the Soil Settler filter screen
1. Wait at least 20 minutes after a cycle for the heating
element to cool down.
2. Unload and slide the bottom rack forward. (Remove
bottom rack if necessary to reach filter screen.)
3. Remove collected particles from the screen with your
fingers or a paper towel.
Before using your dishwasher, remove all packaging
materials. Read this entire Use and Care Guide. You will
find important safety information and useful operating tips.

Using Your New Dishwasher

WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
A power supply of 120 volts, 60 Hz AC, 15 or 20 amps, is
required.
1. Plug into a grounded 3 prong outlet.
2. Rinse aid is essential for good drying. Be sure to fill the
dispenser before you use your new dishwasher. Each
filling will last about 1 to 3 months depending on your
usage.
6

Soil Settler Soil Removal System

4. Replace the bottom rack with the rack bumpers facing
NOTE: Do not clean the dishwasher interior until it has
cooled.

START-UP GUIDE

3. Scrape large food soil and hard items (toothpicks or
4. Properly load the dishwasher. (See "Dishwasher
5. Add detergent. Always use a high-quality brand
6. Push door firmly closed. The door latches
7. Press the desired cycle and option selections. (See
the door.
bones) from dishes.
Loading.") Load dishes with space in between so water
will reach the soiled surfaces. Make sure nothing keeps
the spray arm(s) from spinning freely.
detergent. (See "Dishwasher Use.")
automatically. Run hot water at the sink where you will
connect dishwasher until water is hot. (See
"Dishwasher Efficiency Tips.") Turn off the water and
hook the dishwasher to the faucet. (See "Connecting
the Dishwasher.") Turn on the hot water.
"Dishwasher Use.") Turn the Cycle Control knob to the
desired cycle to start.