Soil Settler Soil Removal System; Start-Up Guide; Using Your New Dishwasher; Stopping Your Dishwasher - Kenmore 665.7441 Series Use & Care Manual

Soil Settler Soil Removal System

The Soil Settler soil removal system cleans by spraying a mixture
of hot, clean water and detergent against soiled dishes.
To clean the Soil Settler filter screen
1. Wait at least 20 minutes after a cycle for the heating element
to cool down.
2. Unload and slide the bottom rack forward. (Remove bottom
rack if necessary to reach filter screen.)
3. Remove collected particles from the screen with your fingers
or a paper towel.
4. Replace the bottom rack with the rack bumpers facing the
door.
NOTE: Do not clean the dishwasher interior until it has cooled.

START-UP GUIDE

Before using your dishwasher, remove all packaging materials.
Read this entire Use and Care Guide. You will find important
safety information and useful operating tips.

Using Your New Dishwasher

WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in
death, fire, or electrical shock.
A power supply of 120 volts, 60 Hz AC, 15 or 20 amps, is
required.
1. Plug into a grounded 3 prong outlet.
2. Rinse aid is essential for good drying. Be sure to fill the
dispenser before you use your new dishwasher. Each filling
will last about 1 to 3 months depending on your usage.
3. Scrape large food soil and hard items (toothpicks or bones)
from dishes.
4. Properly load the dishwasher. (See "Dishwasher Loading.")
Load dishes with space in between so water will reach the
soiled surfaces. Make sure nothing prevents the spray arm(s)
from spinning freely.
5. Add detergent. Always use a quality brand detergent. (See
"Dishwasher Use.")
6. Push door firmly closed. The door latches automatically. Run
hot water at the sink where you will connect dishwasher until
water is hot. (See "Dishwasher Efficiency Tips.") Turn off the
water and hook the dishwasher to the faucet. (See
"Connecting the Dishwasher.") Turn on the hot water.
7. Press the desired cycle and option selections. (See
"Dishwasher Use.") Turn the Cycle Control knob to the
desired cycle to start.

Stopping Your Dishwasher

You can stop your dishwasher anytime during a cycle.
1. Open the door slightly.
2. Wait for the spraying action to stop. Then open the door all
the way, if needed.
3. Close the door to continue the cycle.
OR
1. Turn the cycle control knob slowly clockwise until you hear
water draining. Let the dishwasher drain completely.
2. Open the door.
3. Turn the cycle control knob to Off/Arrêt.
7