Table of Contents
Advertisement
Your system should be located in a protected, dry, level and non-freezing area.
•
We recommend a ½" drain for the backwashing cycles. If possible, the house drain
•
should be no farther than 20 feet from the system. (Always follow local plumbing
codes).
You will need a standard 3-prong, 120V, grounded outlet that is not controlled by a
•
switch. Our Fleck valves have a 5' power cord, but you can use an extension cord if
an outlet is not nearby. Please follow any local building/safety codes if you need to
use an extension cord.
Make a list of all the plumbing fittings you will need to completely install the system
•
to make it ready for operation.
•
Assemble all tools needed to install the system, and start your installation!
1) Pipe Cutters
2) PVC Glue
3) PVC, copper or CPVC pipe
4) Two 1" or ¾" male adapters—Depending on which bypass is ordered.
Tech Support: 1-888-989-7873
Pre Installation
Tools and Materials needed
PURE WATER TREATMENT, INC.
Page 6
Advertisement
Table of Contents
