Table of Contents
Advertisement
•
First turn water supply off.
Make a cut in your line AFTER your pressure tank.
•
Install first ball valve AFTER your pressure tank. (see figure a on page 3)
•
Teflon tape threads on each end of PURE TECH 250.
•
Place rubber o-ring seal in notch then place adaptation cap and screw down tightly.
•
Securely tighten, but be careful not to strip the threads.
Install required plumbing bushings in PURE TECH 250 that matches your pipe size.
•
Install PURE TECH 250 after ball valve. With this installed you will be able to cut
•
the water supply off later to add chlorine.
•
Install spigot after the PURE TECH 250. This will allow you to de-pressurize the
unit.
•
Install second ball valve after spigot. This will allow you to stop the water from back
feeding from any equipment.
DO NOT INSTALL CHLORINE YET.
•
Go to Page 7 section 5 and continue with installation of PURE TECH 3000si
•
Tech Support: 1-888-989-7873
Installation for PURE TECH 250
PURE WATER TREATMENT, INC.
Page 28
Advertisement
Table of Contents
