Table of Contents
Advertisement
PROBLEM
1. System Fails to Backwash
2. Hard Water
3. Loss of Water Pressure
4. Loss of Mineral Through
Drain Line.
5. Iron in Conditioned Water.
8. Control Cycles
Continuously.
9. Drain Flows Continuously.
Tech Support: 1-888-989-7873
Troubleshooting
CAUSE
A. Electrical Service To Unit Has
been interrupted.
B. Timer is Defective
C. Power Failure
A. Bypass Valve is open.
B. Hot Water Tank Hardness.
C. Leak At Distributor Tube.
D. Internal Valve Leak.
A. Iron Buildup in Line to Water
Conditioner.
B. Iron Buildup in Water Conditioner
C. Inlet of Control Plugged Due to
foreign material broken loose from
pipes by recent work done on
plumbing system.
A. Air in Water System.
A. Fouled Mineral Bed.
A. Broken or Shortened Switch.
A. Valve is not Programming
Correctly.
B. Foreign Material in Control.
C. Internal Control Leak.
CORRECTION
A. Assure Permanent Electrical Service.
(Check Fuse, Plug, Pull chain or Switch)
B. Replace Timer.
C. Reset Time of Day.
A. Close Bypass Valve.
B. Repeat Flushings of the Hot Water Tank
is required.
C. Make Sure Distributor Tube is Not
Cracked. Check "O" Ring and Tube
Pilot.
D. Replace Seals and Spacers and/or Piston.
A. Clean Line to Water Conditioner
B. Clean Control and Add Mineral Cleaner
to Mineral Bed. Increase Frequency of
Regeneration.
C. Remove Piston and Clean Control.
A. Assure that Well System has Proper Air
Eliminator Control. Check for Dry Well
Condition.
A. Check Backwash, Brine Increase
Backwash Time.
A. Determine if Switch or Timer is Faulty
and replace it, or Replace Complete
Power Head.
A. Check Timer Program and Positioning
of Control. Replace Power Head
Assembly if not Positioning Properly.
B. Remove Power Head Assembly and
Inspect Bore. Remove Foreign Material
and Check control in Various
Regeneration Positions.
C. Replace Seals and Piston Assembly.
PURE WATER TREATMENT, INC.
Page 24
Advertisement
Table of Contents
