Table of Contents
Advertisement
Tools Used in the Seal and
Spacer Replacement
Nut Driver #12664
Socket Adapter #16906
Socket 7/16" #12665
Seal Hook #12874
Puller #13061
Stuffer #11098
All tools are a part of the
Service Repair Kit #60135-2510
1. Turn off water supply to valve. Next, cycle
valve to backwash position, then to service.
Now remove electrical plug from outlet.
2. Remove control box cover.
3. Disconnect the brine line from the injector
housing to the brine valve (if your unit has
timed brine tank fill).
4. Remove the two capscrews that hold the back
plate to the valve.
5. Grasp the back plate on both sides and slowly
pull end plug and piston assembly out of the
valve body, (see Fig. 1) and lay aside.
6. Remove the seal first using the wire hook with
the finger loop (see Fig.2).
7. The spacer tool (use only for removing the
spacers) has three retractable pins, retained by
a rubber ring, at one end; they are retracted
or pushed out by pulling or pushing the center
button the opposite end.
8. Insert the pin end of the spacer tool into the
valve body with the pins retracted (button
pulled back). Push the tool tight against the
spacer and push the button in, (see Fig. 3).
When the button is pushed in, the pins are
pushed out to engage the 1/4 dia. holes in the
spacer. Remove the tool from the valve body.
The spacer will be on the end. Pull the center
button back, the pins will be retracted and the
spacer can be removed from the spacer tool.
Tech Support: 1-888-989-7873
Seal and Spacer Replacement
Fig. 1 Removing Power Head
and Piston Assembly
Fig. 2 Removing Special Tool From
Valve Body after Inserting Seal
PURE WATER TREATMENT, INC.
Page 25
Advertisement
Table of Contents
